Size of Board: 56mm WIDE x 40mm HEIGHT (1590B BOX OK)
Two pads near the output pad are for HP/LP switch.
R14 is 220k only found in certain version of OCD.
Use ZERO ohm resistor or JUMPER WIRE where the resistance has “JMP” value.
Size of board: 54mm X 30mm (1590B Size Box OK)
Additional slot allocated (Clean) to lift up diode clipper.
This make pedal to work as a clean boost.
Pot are arrange in this sequence.
GAIN –> BITE –> CUT –> VOLUME.
I had not build this to confirm the layout.
But this layout match with the schematic as found in this link.
http://i180.photobucket.com/albums/x176/lynessmy/RedSnapper_SCM.png
Sizes of Board: 78mm WIDE x 40mm Height (This board doesn’t fit onto 1590B! I’ll redrawn once i have time)
PROBE WAH work alike.
ANT is to connect to ANTHENA to sense the rocking movement of your feet.
PCB Blank with sized 120×90 mm reported to work great. You are encouraged to experiment in this area.
The original uses VACTROL. This layout is created for LED-LDR in heat shrink tube.
10 mm pitch sized is allocated. So bend your 3mm LED and LDR accordingly.
Sensitivity is to adjust the sensitivity of you movement.
Tune is to set the intensity range of the LED.
These 2 controls are internal trimmer in the original but i pull it out for tune-ability.
However, i’m not sure how useful it will be.
I have not build this layout but it is in my TO BUILD list.
If above picture doesn’t appeared as full PCB, please download it to your local for viewing.
It is just limited by the blog’s frame.
Enjoy…
ZV MACHINE
Size of board: 62mm Wide x 37 mm Height. (This board doesn’t fit onto 1590B! I’ll redrawn once i have time)
This is not my flavour. I’m NOT gonna build this.
Let me know if you had sucessfully build ZV Machine with this layout so that i can classified it as VERIFIED!!!.
